Aaeromac Air Conditioning Specialists
AC in Gold Coast

A stitch in time saves nine’ prevention is better than cure’. No doubt you have heard these sayings time and time again over the years and their message is honest as apropos today as they have ever been. Maintenance and service is a necessity and this is true with maximum machines, but especially with air conditioning. Poorly serviced air conditioners can lead to all kinds of trouble, including inefficient and costly performance, racket issues and health problems, impartial to name few. Air Repair is AEROMAC’s service division and offers all types of maintenance and service requirements. Just like a new car, your air conditioner requires steady servicing to maintain the systems' efficiency and to help detect problems earlier they become a major issue. We are happy to send out a service reminder to you when your system is due for its maintenance. During a service, we perform the subsequent checks and processes. Beginning step is to eternal check the circuit breaker in the switch board is on and also there may be an isolator adjacent to the outdoor unit (condenser) that must also be switched on. Are the batteries in the secluded controller calm charged? The Daikin systems have protection devices built in that will hinder the unit from operating if the system goes out of its operation parameters. If this happens, go to the outside condensing unit and turn off the electrical isolator that is adjacent to the condenser or at the switchboard circuit breaker marked Air Conditioner or AC. Depart the switch in the OFF’ position for 5 minutes, then turn it back to ON’. If the return air grille is noisy, it is usually an indication that the filter is dirty and needs to be cleaned. You can do this be vacuuming it or by rinsing it under water and letting it dry. The system is a reverse cycle unit, meaning it heats and cools. However, you need to be sure that you have it set to the correct MODE. If, for example, it is July and you want to heat your home, and the MODE is set to COOL, it doesn’t matter if the temperature is set to 30 degrees, it will not heat while in COOL MODE. You need to the change the setting to HEAT. The reverse of this applies for the summer months, i.e. the system needs to be in COOL MODE. Your home is divided up into zones, usually you will have a constant and a number of delectable zones. The number of zones that can be selected on vary depending on the home and the size of the system installed. A good way to tell if the correct number of zones are selected on is if there is a noise tomorrow from the air rushing’ through the supply vents, then you need to amplify the number of zones selected. Alternatively, if the home is taking a lengthy time to cool down or heat up, then reduce the number of zones selected on.